Precision positioning method for woodworking CNC Router
For machining accuracy of the workpiece is not high, we can adjust the position of the tool by the naked eye, and then finally determine the lower part of the origin, such a positioning method has a lot of errors. So how to use woodworking CNC Router ( http://www.roc-tech.com/product/product29.html ) to more accurate positioning is also a lot of scientific methods. Here we look at the most common way of operation.
Positioning must first from material fixed start. Here the fixation is not said the material with the fastening clamp good finished the material also is placed. Using our CNC CNC Router can accurate material is, in spindle clamping a sword, then the tool fell on the table, along one side of the material to run about, to find materials are based on the a side and tool direct gap. The material is fixed after the adjustment. Then the next work is carried out to determine the origin of the material. X direction and Y direction is determined by the same method, here we will only say that the X direction. First through the trimming tool slowly close to the materials left, hand gently rotating cutter, until the tool has just come into contact with the material can be, then this x workpiece left cleared, then the lift tool, move to the right, the same is the tool just contact to the right side of the material can be down at the X workpiece coordinate. Then the general position of this value is the center of the material X direction. Y direction is the same reason. This woodworking CNC Router X and Y direction of the center is determined, it is equivalent to the origin of the workpiece.
With the above positioning method, it is believed that it can be accurately located.